In recent years, the slope protection mold industry has developed rapidly. In addition to the introduction of advanced equipment and technology, hexagonal slope protection mold manufacturers have also trained a group of excellent R&D designers, and from time to time have increased the research and development of various molds. The design and production of a series of excellent plastic slope protection brick molds, the main products are hexagonal slope protection brick molds, hollow slope protection brick molds, solid slope protection brick molds, water Conservancy slope protection brick molds, road slope protection brick molds and other series of molds products. I also according to the actual needs of customers, comprehensive consideration of working conditions, reasonable selection of mold materials to improve the life of the mold.
The hexagonal slope protection mold is generally produced using plastic as raw material. Since it is a plastic product, there is a common feature. The plastic product is most afraid of exposure to the sun. Therefore, during the construction process, try not to expose the slope protection mold to direct sunlight. place, Construction should be in the factory building or in the shade, so as to ensure that the slope brick mold is not exposed to the sun, effectively prevent the mold aging. Although the quality of the mold is very good, it is generally not easy to be cracked, so we can not take into account the mold's ability to bear, but also take lightly, can not be forced to fall to the ground, so that even in a good slope brick mold, It can not withstand severe impact, so it is better to act normally. Slope protection brick mold to meet the requirements of good gloss on the surface of the plastic, generally to polish the mold cavity, polishing performance of the mold requirements are high, the brighter the surface, the better, the roughness is very small. Therefore, the mold material is required to be easily polished, and the mold and other materials should not have holes, impurities and other defects. The hexagonal slope protection mold needs to be very careful when it is molded, because to prevent damage, some people think that the slope protection brick is put on the roadside anyway, and the bad point is nothing, but the slope protection brick is not the same as the brick of the wall. The bad place can be knocked down with a hammer and then used. The wall needs cement to be finished with bricks. However, the slope protection bricks are not needed. The missing slope protection bricks have an impact on the appearance of the city. Therefore, the damage of the slope protection bricks should be reduced as much as possible.